Skip to main content
Mitratech Success Center

PolicyHub Application Guide v5.0.0.0

PolicyHub Application Guide v5.0.0.0

The information in this document is subject to change without notice and describes only the product defined in the title and or introduction of this document. This document is intended for the use of customers of Hitec (Laboratories) Ltd, only for the purposes of the agreement under which the document is submitted and no part of it may be reproduced or transmitted in any form or means without the prior written permission of Hitec (Laboratories) Ltd. The document has been prepared to be used by professional and properly trained personnel and the customer assumes full responsibility when using it. Hitec (Laboratories) Ltd welcomes customer comments as part of the process of continuous development and improvement of its documentation.

Information or statements given in this document concerning the suitability, capacity, or performance of the mentioned hardware or software products cannot be considered binding but shall be defined in the agreement made between Hitec (Laboratories) Ltd and the customer. However, Hitec (Laboratories) Ltd have made all reasonable efforts to ensure that the instructions contained in this document are adequate and free of material errors and omissions. Hitec (Laboratories) Ltd will, if necessary, explain issues which may not be covered by this document.

Hitec (Laboratories) Ltd’s liability for any errors in this document is limited to the documentary correction of errors. Hitec (Laboratories) Ltd WILL NOT BE RESPONSIBLE IN ANY EVENT FOR ERRORS IN THIS DOCUMENT OR FOR ANY DAMAGES, INCIDENTAL OR CONSEQUENTIAL (INCLUDING MONETARY LOSSES), that might arise from the use of this document or the information in it.

This document and the product it describes are considered protected by copyright according to the applicable laws.

PolicyHub is a registered trademark of Hitec (Laboratories) Ltd.

Other product names mentioned in this document may be trademarks of their respective companies and they are mentioned for identification purposes only.

Hitec (Laboratories) Ltd welcomes customer comments as part of the process of continuous development and improvement of its documentation.

  • Was this article helpful?